What should be paid attention to when using the co

2022-07-23
  • Detail

What should be paid attention to when using the combine

several key points that must be paid attention to when using the combine harvester:

the service life, failure rate, safety and reliability of any machine, in addition to the manufacturing quality of the machine itself, are also closely related to the use and maintenance of the machine. The use of combine harvesters is no exception, and the following points should be paid attention to:

1. The machine operator must receive formal training from the manufacturer, distributor or relevant departments before taking the post. If you are not clear about the working principle and operating requirements of the combine, it is difficult to use the combine well. Therefore, before using the machine, you must participate in the operation training on the need to make early preparations for the combine and take over the harvester in advance, and obtain the driver's license

2. Read the product manual carefully before use. Because of the complex structure of the combine harvester, although the quality of the machine is very good, if you don't understand the internal structure and use method, you can use it casually by experience. If you don't follow the instructions, such as the film produced by the PP film blowing machine, which is suitable for all kinds of supermarket shopping bags, fungus bags and other bags with high hardness and low requirements for tensile strength and brightness, the machine is prone to the failure of not often neglecting the attachment

3. Because the harvested crop conditions are very different (such as crop variety, maturity, moisture content, yield, crop height and lodging conditions, etc.), during the use of the combine, the relevant mechanisms of the machine should be adjusted timely according to the changes of crop conditions to ensure the operating performance of the combine

4. The safety protection device installed on the combine is set to protect the safety of the operator and its related personnel. Therefore, the machine cannot be disassembled during operation or work. If it has been disassembled during the planned ground repair, the machine must be reinstalled before operation or work. In addition, during machine operation, the requirements of relevant safety warning signs must be followed to avoid accidents

5. The combine should be inspected, maintained and maintained frequently and timely. For example, check whether there is lack of oil, water, looseness, open welding, abnormal sound, etc. If there is any abnormality, it shall be supplemented, adjusted and repaired in time. The machine shall not be allowed to work with a fault, otherwise it is prone to major failure or damage

6. In most cases, the structure of the combine and the parameters of the whole machine are coordinated in design and cannot be changed or refitted at will. For example, increase the engine speed and grain tank height. This will not only ensure the operating performance, but also accelerate the wear and damage of the machine

Copyright © 2011 JIN SHI